Mini CM410X DSMX DSM2 SPEKTRUM Compatible 4CH 2.4GHz Rx micro mini receiver

Description

Specs:
Channel: 4Channel+ PPM PortModulation:  DSM2/DSMXBand:  2.4GHzDimensions (W x Lx H): 29x 15x4 mmWeight:  2gVoltage Range: 3.3-12v （HV）Brown-Out Voltage: 4.0v  (Always supply power above this voltage)Expected Range: 800m (tested with JR DSX9)Pin spacing for channel/servo connector : 1.25mm
Features:
4channels with PPM OutPatent pending Model Match prevents flying a model using the wrong model memory (feature does not work with module systems)Servo Sync (feature does not work with module systems)Preset failsafe systemQuick ConnectCompatibility (Spectrum and JR DSM2 /DSMX): DX6I,DX7,DX8, DSX7,DSX9 DSX11
Binding Procedure
I. Press bind-button connect power to receiver, please make sure radio in binding process. Receiver LED quick flash then green LED keep light it means bind is accomplished.
II. Please make sure the transmitter in binding process.
III. To set fail-safe throttle and control surface positions, (minimum throttle and all control surfaces set to neutral is suggested). Press and hold the bind button of transmitter (LED will illuminate), Turn on the transmitter.
IIII. Receiver LED will change from rapid flashing to slow flashing and a few seconds later when bind is accomplished the LED of receiver will illuminate solid. Failsafe should be programmed correctly .
IV. Remove binding harness from the BIND channel.  Restart the receiver by cycling it power off and turn on and connect battery into BIND channel is recommended. All channels should function properly now.  You may test fail-safe by holding sticks in corner, cycle transmitter on and off.  Surfaces and throttle should return to your preset fail-safe positions.
Notes: Only one time bind procedure is required on a new receiver.  Repetitive binding provides no extra security.  Always remember to remove the binding harness after successful bind is completed.
On Aug-19-21 at 01:35:03 PDT, seller added the following information: